ADAS calibration in Phoenix
Windshield camera calibration after a new windshield
If your car has a camera at the top of the windshield, it reads the road for lane-keeping and automatic braking. When the windshield is replaced, that camera has to be calibrated again so it aims where the carmaker designed it to. We check your car before the job and tell you what it needs.
What ADAS calibration is
ADAS stands for advanced driver-assistance systems. The forward camera behind your windshield is one of them. Calibration is the procedure that tells the camera where straight ahead is after the glass around it has changed.
A camera that aims a little off can still look fine on the dashboard. The error shows up far down the road, where lane lines and the car ahead are small in the picture.
Which cars need it after a windshield replacement
Most cars with a camera mounted on the windshield. Carmakers say so in their own repair documents. General Motors calls for a calibration whenever the windshield is removed and replaced on a vehicle with a front camera. Ford lists ADAS recalibration after windshield replacement among its required procedures. Honda names a windshield replacement as a reason the camera must be aimed again.
Not sure if your car has one? Look behind the rearview mirror for a dark housing at the top of the glass, or call us with your VIN and we will check.
Static and dynamic calibration
Carmakers use two kinds of calibration. A static calibration is done with the car parked in front of printed targets set at measured distances. A dynamic calibration is done by driving on well-marked roads while a scan tool watches the camera relearn the lane lines. Depending on the model, a car needs one of these or both.
Static calibration needs a level floor, steady light and room for the targets. Honda, for one, says to aim its cameras in a well-lit area such as inside a shop and to avoid doing it outside. When your car needs a procedure that cannot be done where it is parked, we tell you before the job and plan where it will happen.
The glass matters as much as the calibration
A camera can only see as well as the glass in front of it. Some carmakers, among them Honda, Ford and General Motors, say in their own documents that only their genuine glass should go into a camera-equipped windshield. Before we order your windshield, we tell you what your carmaker calls for so you can choose with the facts in hand.
What to expect on the day
- We confirm the camera and the other windshield features from your VIN before the job.
- The windshield goes in first, and the urethane gets the cure time it needs.
- The camera is calibrated with the procedure set for your make and model.
- If a driver-assistance warning stays on afterward, call us so we can check it.
Questions people ask
Do I need a calibration after every windshield replacement?
If the camera is mounted on the windshield, almost always. General Motors, for example, calls for it every time the windshield is replaced. A car with no windshield camera does not need one.
Can the calibration be done at my home?
Some procedures can be done where the car is parked and some cannot. Static calibrations need a level floor and steady light. We tell you before the job which kind your car needs and where it will be done.
How long does a calibration take?
It depends on the car and the procedure. We give you an estimate when we confirm your vehicle on the call.
A warning light came on after my new windshield. What now?
Call us at (623) 462-9050. A camera warning after a windshield replacement can mean the camera needs a calibration or a second check.
Ready for a quote?
Call with your year, make and model, or your VIN.